VLX1570 |
| Katalog-Nr.GC19378 |
VLX1570 ist ein kompetitiver Inhibitor von Proteasom-Deubiquitinasen (DUBs) mit einem IC50 von etwa 10 μM.
Products are for research use only. Not for human use. We do not sell to patients.
Cas No.: 1431280-51-1
Sample solution is provided at 25 µL, 10mM.
VLX1570, an analogue of b-AP15, is a competitive inhibitor of deubiquitinase activity, with an IC50 of appr 10 uM.
VLX1570 inhibits USP14 and UCHL5 activity of 19S regulatory particles, and the inhibition of USP14 is more pronounced. VLX1570 (1 uM) shows inhibitory activity against USP14 in KMS-11 myeloma cells. VLX1570 exhibits an IC50 of 0.58 uM on HCT116 cells[1]. VLX1570 binds to recombinant USP14 with Kd of 1.5-18 uM using two different sources of recombinant protein, and the Kd for recombinant UCHL5 is higher (14-18 uM) compared to that of USP14. VLX1570 has potent antiproliferative activities on multiple myeloma cells, with IC50s of 43 ± 2 nM, 74 ± 2 nM, 126 ± 3 nM, and 191 ± 1 nM for KMS-11, RPMI8226, OPM-2, and OPM-2-BZR cells, respectively[2]. VLX1570 suppresses the viability of BCWM.1 cells, with an EC50 of 20.22 nM. VLX1570 (100, 250, 500 nM) induces significant apoptosis by 12 h in a dose-dependent manner in all Waldenstrom macroglobulinemia (WM) cell lines tested, including BCWM.1/IR (IR) and BCWM.1/BR (BR) subclones. VLX1570 (100, 250, 500 nM) also causes ER stress machinery and mitochondrial damage in WM cells. VLX1570 (250 nM) downregulates BCR-signalosome components and their end effectors, as well as CXCR4 expression in WM cells[3].
VLX1570 (3 mg/kg) significantly decreases tumor growth in mice bearing KMS-11 multiple myeloma cells[2]. VLX1570 (4.4 mg/kg, i.p.) markedly suppresses tumor growth, without obvious weight loss and other signs of systemic toxicity in the Waldenstrom macroglobulinemia (WM)-bearing mice[3].
References:
[1]. Wang X, et al. Synthesis and evaluation of derivatives of the proteasome deubiquitinase inhibitor b-AP15. Chem Biol Drug Des. 2015 Nov;86(5):1036-48.
[2]. Wang X, et al. The proteasome deubiquitinase inhibitor VLX1570 shows selectivity for ubiquitin-specific protease-14 and induces apoptosis of multiple myeloma cells. Sci Rep. 2016 Jun 6;6:26979.
[3]. Paulus A, et al. Coinhibition of the deubiquitinating enzymes, USP14 and UCHL5, with VLX1570 is lethal to ibrutinib- or bortezomib-resistant Waldenstrom macroglobulinemia tumor cells. Blood Cancer J. 2016 Nov 4;6(11):e492.
Kinase experiment: | Preparations of 26S proteasomes (1 nM) are pretreated with DMSO, VLX1570, or b-AP15 for 2 min in assay buffer (25 mM Tris, 5 mM MgCl2, 10% glycerol, 0.05 mg/mL BSA, 2 mM ATP, and 1 mM DTT) before addition of Ubrhodamine. Fluorescence is monitored at 37°C using Ex/Em = 490 nm/520 nm to read data every 10 second for 30 min using a TECAN infinite 200 instrument. For UbVS labeling of KMS 11 cells, cell pellets are lysed from control or treated cells with buffer (50 mM HEPES pH 7.4, 250 mM sucrose, 10 mM MgCl2, 2 mM ATP, 1 mM DTT) on ice for 30 min and removed debris by centrifugation. Twenty five μg of protein is labeled with 1 μM UbVS for 30 min at 37°C. Samples are resolved by SDS-PAGE and subjected to immunoblotting. For UbVS labeling of proteasomes, purified 19S proteasomes (50 nM) are pretreated with DMSO, VLX1570, or b-AP15 (50 μM) for 10 min at room temperature, followed by labeling with 1 μM HA-UbVS for 30 min at 37°C and by immunoblotting[1]. |
Cell experiment: | Cell viability is monitored by the MTT (3-(4,5-dimethylthiazol-2-yl)-2,5-diphenyltetrazolium bromide) assay. For the MTT assay, cells are suspended at 5 × 105 cells/mL, and 100 μL aliquots are dispended into 96-well microtiter plates and exposed to drugs using DMSO as control. At the end of incubations, 10 μL of a stock solution of 5 mg/mL MTT (3-(4,5-dimethylthiazol-2-yl)-2,5-diphenyltetrazolium bromide), is added into each well, and the plates are incubated 4 hours at 37°C. Formazan crystals are dissolved with 100 μL of 10% SDS/10 mM HCl solution overnight at 37°C. Since MTT assays are affected by mitochondrial activity, and since OXPHOS is affected by VLX1570, the acid phosphatase method49 are used to determine cell viability in some experiments. After washing twice with PBS, cells are lysed in 100 μL of 0.1 M sodium acetate, 0,1% Triton X-100, p-nitrophenylphosphate and incubated for 90 min at 37°C. At the end of the incubation, 10 μL NaOH is added to each well and A405 is determined[2]. |
Animal experiment: | Animal experiment is performed with a sample size of 7 per group, 80% power at the 5% significance level to detect a difference in means of 1800 mm3 between the 2 groups. For percentage change in IgM from baseline, with a sample size of 7 per group, 80% power at the 5% significance level is calculated to detect a difference in means of 450% between the 2 groups. Fourteen female NOD/SCID mice (6-8 weeks of age) are subcutaneously implanted with 1× 106 luciferase labeled RPCI-WM1 cells (Luc-RPCI-WM1), which are allowed to grow till a bioluminescent signal is observed by IVIS imaging (Day 20). On day 21, mice are randomized into 2 groups (n=7 each), with one group receiving vehicle (cremaphor+PEG+Tween) and the other receiving VLX1570 at 4.4 mg/kg via intraperitoneal injection. The investigator is not blinded to the group allocation. Both groups are respectively treated with either vehicle or VLX1570 every alternate day for 22 days. Sizes of the tumors is measured every 3- 4 days using direct caliper measurements, and volume of the tumorsis calculated using the formula (width)2 × length/2. Bioluminescent tumor imaging is performed with the Xenogen imaging system on Days 0, 20, 30, 36 and 43 post-tumor implantation. Blood from mice is collected on the same days by submandibular venous puncture, with sera subsequently separated for quantification of human IgM levels’ using ELISA. On Day 44, mice are sacrificed, and final tumor volume is measured in control and treatment arms. All images are obtained using a Canon D40 digital camera. No specific criteria for inclusion/exclusion are used as all mice formed tumors and are therefore included into the study[3]. |
References: [1]. Wang X, et al. Synthesis and evaluation of derivatives of the proteasome deubiquitinase inhibitor b-AP15. Chem Biol Drug Des. 2015 Nov;86(5):1036-48. | |
| Cas No. | 1431280-51-1 | SDF | |
| Canonical SMILES | O=C1/C(CN(C(C=C)=O)CC/C1=C\C2=CC=C(F)C([N+]([O-])=O)=C2)=C/C3=CC=C(F)C([N+]([O-])=O)=C3 | ||
| Formula | C23H17F2N3O6 | M.Wt | 469.39 |
| Löslichkeit | DMSO : ≥ 32 mg/mL (68.17 mM) | Storage | Store at -20°C |
| General tips | Please select the appropriate solvent to prepare the stock solution according to the
solubility of the product in different solvents; once the solution is prepared, please store it in
separate packages to avoid product failure caused by repeated freezing and thawing.Storage method
and period of the stock solution: When stored at -80°C, please use it within 6 months; when stored
at -20°C, please use it within 1 month. To increase solubility, heat the tube to 37°C and then oscillate in an ultrasonic bath for some time. |
||
| Shipping Condition | Evaluation sample solution: shipped with blue ice. All other sizes available: with RT, or with Blue Ice upon request. | ||
| Prepare stock solution | |||
|
1 mg | 5 mg | 10 mg |
| 1 mM | 2.1304 mL | 10.6521 mL | 21.3042 mL |
| 5 mM | 426.1 μL | 2.1304 mL | 4.2608 mL |
| 10 mM | 213 μL | 1.0652 mL | 2.1304 mL |
Step 1: Enter information below (Recommended: An additional animal making an allowance for loss during the experiment)
Step 2: Enter the in vivo formulation (This is only the calculator, not formulation. Please contact us first if there is no in vivo formulation at the solubility Section.)
Calculation results:
Working concentration: mg/ml;
Method for preparing DMSO master liquid: mg drug pre-dissolved in μL DMSO ( Master liquid concentration mg/mL, Please contact us first if the concentration exceeds the DMSO solubility of the batch of drug. )
Method for preparing in vivo formulation: Take μL DMSO master liquid, next addμL PEG300, mix and clarify, next addμL Tween 80, mix and clarify, next add μL ddH2O, mix and clarify.
Method for preparing in vivo formulation: Take μL DMSO master liquid, next add μL Corn oil, mix and clarify.
Note: 1. Please make sure the liquid is clear before adding the next solvent.
2. Be sure to add the solvent(s) in order. You must ensure that the solution obtained, in the previous addition, is a clear solution before proceeding to add the next solvent. Physical methods such as vortex, ultrasound or hot water bath can be used to aid dissolving.
3. All of the above co-solvents are available for purchase on the GlpBio website.
Quality Control & SDS
- View current batch:
- Purity: >98.00%
- COA (Certificate Of Analysis)
- SDS (Safety Data Sheet)
- Datasheet
Average Rating: 5 (Based on Reviews and 13 reference(s) in Google Scholar.)
GLPBIO products are for RESEARCH USE ONLY. Please make sure your review or question is research based.
Required fields are marked with *















