Accueil>>Kits>>TRIzol Reagent

TRIzol Reagent

Catalog No.GK20008

Le réactif TRIzol est un produit qui peut extraire l'ARN à partir d'échantillons animaux et végétaux.

Products are for research use only. Not for human use. We do not sell to patients.

TRIzol Reagent Chemical Structure

Taille Prix Stock Qté
100mL
100,00 $US
En stock
200mL
180,00 $US
En stock

Tel:(909) 407-4943 Email: sales@glpbio.com

Avis des clients

Based on customer reviews.

  • GlpBio Citations

    GlpBio Citations
  • Bioactive Compounds Premium Provider

    Bioactive Compounds Premium Provider

Sample solution is provided at 25 µL, 10mM.

Product has been cited by 19 publications

Product Documents

View current batch:

Protocol

Self-provided reagents

Chloroform, isopropanol, 70% ethanol (DEPC water configuration), Rnase Free H2O.

Ⅰ Preparation before experiment

The key to RNA preparation is to inhibit RNA degrading enzymes in cells and prevent contamination of RNA degrading enzymes in the equipment and reagents used. Therefore, the following measures must be taken in the experiment: wear disposable clean gloves; use a special experimental bench for RNA operation; avoid talking during the operation, etc. The above methods can prevent the contamination of the experimenter's sweat and saliva by RNA degrading enzymes.

Cautions:
1. Try to use disposable plastic utensils. If glassware is used, it should be treated with 0.1% DEPC aqueous solution at 37°C for 12 hours before use, and then autoclaved at 120°C for 30 minutes to remove residual DEPC.
2. Reagents used for RNA experiments must be sterilized by dry heat (180°C, 60min) or in glass containers after DEPC water treatment and sterilization using the above methods (disposable plastic containers for RNA experiments can also be used) , The sterile water used must be treated with 0.1% DEPC and then autoclaved.
3. Reagents and sterile water for RNA experiments should be dedicated to avoid cross-contamination after mixing.

Ⅱ Experimental operation

The usage of TRIzol Reagent is as follows

Sample type Sample size Usage of TRIzol
Adherent cultured cells 10 cm2 1 mL
Suspension culture cells 1x106-10x106 1 mL
Common tissue samples (muscle, etc.) 50-100 mg 1 mL
Special tissue samples (liver, spleen, etc.) 30-50 mg 1-2 mL
Plant tissue 30-50 mg 1 mL
Leukocyte 1x106 1 mL

Sample size and RNA yield

Sample type Sample size RNA yield
Leukocyte 1x106 10~20 μg
Plant tissue 25 mg 10~20 μg
Cells 1x106 8~15 μg
Tissues such as muscle/brain 50 mg 10~25 μg
Liver 50 mg 100~300 μg

TRIzol usage instructions

Adherent cells Suspension cells, yeast, bacteria Animal and Plant tissue
1. Sample pretreatment Pour out the culture solution from every 10 cm2 of the cultured cells and wash them with PBS once to remove as much excess solution as possible. Pour the suspension cultured cells together with the culture solution into a centrifuge tube, centrifuge at 8,000 rpm for 2 min, discard the supernatant, and add 50μl of sterile water to resuspend the cells until there is no obvious precipitation. Transfer the sample to a mortar pre-cooled with liquid nitrogen, grind the tissue with a pestle, and continuously add liquid nitrogen in the meantime until it is ground into a powder.
2. Add TRIzol Add 1 ml of TRIzol to distribute the lysate evenly on the cell surface, and then use a pipette to blow the cells off. Transfer the cell lysate to a 1.5ml EP tube. Add 1ml TRIzol. Add the ground tissue to a 1.5 ml EP tube containing 1 ml TRIzol.
3. Lysed sample After adding TRIzol, immediately turn it upside down with wrist force until the cells and tissue powder are evenly dispersed without lumps. Leave it at room temperature for 5 minutes to completely separate the nucleic acid-protein complexes.
4. Add Chloroform Add 200 μl chloroform, shake vigorously with the wrist for 15 seconds, and leave it at room temperature for 2 minutes.
5. Centrifugal layering Centrifuge at 13,000 rpm for 10 minutes, and transfer 600 μl of colorless supernatant to a new 1.5EP tube.
6. Add isopropanol Add 600 μl of isopropanol to the above 600 μl of supernatant, turn it upside down several times vigorously with the wrist, and place it at -20°C for 5 minutes.
7. Centrifugation of total RNA Centrifuge at 13,000 rpm for 10 min, carefully discard the supernatant, and save the bottom total RNA pellet.
8. Rinse total RNA Add 1ml of 70% ethanol to each tube of the pellet, turn it upside down several times, and centrifuge at 13,000 rpm for 5 min. Carefully discard the supernatant and save the bottom RNA pellet.
9. Repeat the rinse one more time Repeat step 8 and wash again.
10. Volatile residual ethanol Pour off the washing solution, centrifuge again for a short time for 10 seconds, absorb the remaining washing solution with a 10 μl tip, and place it at room temperature to evaporate the ethanol (~20min).
11. Dissolve total RNA Add 20-100μl TE Buffer or RNase Free H2O to each tube to dissolve total RNA.

Common problems

1. Low extraction rate. Possible reasons: (a. Sample lysis or homogenization is not complete; b. RNA precipitation is not completely dissolved)
2.A260/A280<1.65. Possible reasons: (a. When measuring the absorbance, the RNA sample was not dissolved in water, but dissolved in TE; b. The amount of tissue added when the sample was homogenized was too much; c. After stratification, the supernatant was less than 500μl; d. The organic phase was mixed in the water phase)
3. Excessive DNA contamination. Possible reasons: (a. The amount of reagents added during sample homogenization is too small or the amount of tissue is too much; b. The sample contains organic solvents) Solution: using this reagent usually genomic DNA contamination content <0.1ng/μl, if it is necessary to remove DNA contamination completely, please use Rnase Free DNase I (HaiGene: A3001) to digest and remove genomic DNA contamination. If you use the Gold Medal cDNA First Strand Reverse Transcription Kit (HaiGene: D0401) (HaiGene: D0401), there is no need to digest to remove genomic DNA contamination in advance. The kit contains reagents to remove genomic DNA contamination.

Background

Le réactif TRIzol est un produit qui peut extraire l'ARN à partir d'échantillons animaux et végétaux. L'échantillon peut être entièrement lyser dans le réactif TRIzol. Pendant l'homogénéisation ou la lyse de l'échantillon, il peut maintenir l'intégrité de l'ARN tout en lysant les cellules et en dissolvant leur contenu. Le réactif TRIzol a un large spectre puissant et peut être appliqué à l'extraction d'ARN total à partir de divers échantillons. Le processus d'extraction est pratique et rapide, et toute l'opération peut être effectuée en une heure. Ce réactif convient aux petits échantillons (50-100 mg de tissu, 1x106 cellules) ainsi qu'aux grands échantillons (≥1g de tissu, >107 cellules). Il est applicable aux humains, aux animaux, aux tissus végétaux et bactériens, et peut traiter un grand nombre d'échantillons différents simultanément ; le processus complet d'extraction pouvant être terminé en une heure. L'ARN total isolé ainsi que les protéines et ADN sont extrêmement peu contaminés ; ils peuvent donc être utilisés pour des techniques telles que Northern Blotting, la transcription inverse, le criblage polyA , la traduction in vitro ,l’analyse RNase protectionet clonage génique .

Features & Properties

Applications• Permits the isolation of RNA, DNA, and protein from the same sample
• Offers superior lysis capability, even with difficult sample types
• Optimized formulations and protocols for tissues, cells, serum, virus, and bacteria
ShippingShip with blue ice.
Storage ConditionsStore at 2-8°C,protected from light for 2 years.
UsageFor research use only! Not for use on humans.

Related Video

    TRIzol Reagent- GlpBio

Avis

Review for TRIzol Reagent

Average Rating: 5 ★★★★★ (Based on Reviews and 25 reference(s) in Google Scholar.)

5 Star
100%
4 Star
0%
3 Star
0%
2 Star
0%
1 Star
0%
Review for TRIzol Reagent

GLPBIO products are for RESEARCH USE ONLY. Please make sure your review or question is research based.

Required fields are marked with *

You may receive emails regarding this submission. Any emails will include the ability to opt-out of future communications.