Verucerfont |
|
Catalog No.GC19374
|
Verucerfont es un antagonista del receptor 1 del factor liberador de corticotropina (CRF1) con IC50 de ~6.1, >1000 y >1000nM para CRF1, CRF2 y CRF-BP, respectivamente.
Products are for research use only. Not for human use. We do not sell to patients.
Cas No.: 885220-61-1
Sample solution is provided at 25 µL, 10mM.
Verucerfont is a corticotropin-releasing factor receptor 1 (CRF1) antagonist with IC50s of ~6.1, >1000 and >1000 nM for CRF1, CRF2, and CRF-BP, respectively.
Post hoc analysis shows that the prototypic non-peptide CRF1 receptor antagonist NBI30775 (R121919) and Verucerfont are both significantly different from vehicle, CP-316 311, and pexacerfont (PPost hoc analysis shows that both NBI30775 and Verucerfont inhibit ACTH release throughout the following 6 h of measurement (P<0.001 vs vehicle at each time-point, and vs the respective pretreatment baseline)[1].
References:
[1]. Schwandt ML, et al. The CRF1 Antagonist Verucerfont in Anxious Alcohol-Dependent Women: Translation of Neuroendocrine, But not of Anti-Craving Effects. Neuropsychopharmacology. 2016 Nov;41(12):2818-2829.
|
Animal experiment: |
Male Sprague-Dawley rats are received at 175 to 200 g and housed in a 12 to 12 light cycle for 1 week before adrenalectomy. Rats are adrenalectomized at Neurocrine Biosciences, and NaCl is replenished. Adrenalectomy is verified by plasma corticosterone measurements. Seven days after adrenalectomy, rats are implanted with femoral vein catheters. After ~4 days, rats are prepared for blood sampling by attaching their catheters to PE50 tubing and a syringe, and acclimated to individual opaque sampling cages for 1 h. These cages allow sampling to occur without disturbance to the rat. Blood samples (0.3 mL) are taken after acclimation and blood volumes are replaced with 5 U/mL heparinized saline. Blood samples are stored on ice with EDTA. After a baseline blood sample, rats receive oral doses of either vehicle at 5 mL/kg or the respective drug (including Verucerfont) in the same volume of vehicle. In each case, the dose is 10 mg/kg, based on prior pharmacokinetic studies showing that this dose results in adequate and comparable exposure. Blood samples are taken 1, 2, 3, 4, and 6 h later. Plasma is separated by centrifugation at 4°C and stored at -80 °C for subsequent measurement of ACTH by radioimmunoassay[1]. |
|
References: [1]. Schwandt ML, et al. The CRF1 Antagonist Verucerfont in Anxious Alcohol-Dependent Women: Translation of Neuroendocrine, But not of Anti-Craving Effects. Neuropsychopharmacology. 2016 Nov;41(12):2818-2829. |
|
| Cas No. | 885220-61-1 | SDF | |
| Canonical SMILES | CC[C@H](NC1=CC(C)=NC2=C(C3=CC=C(OC)C=C3C)C(C)=NN12)C4=NC(C)=NO4 | ||
| Formula | C22H26N6O2 | M.Wt | 406.48 |
| Solubility | DMSO : 86.7 mg/mL (213.29 mM) | Storage | Store at -20°C |
| General tips | Please select the appropriate solvent to prepare the stock solution according to the
solubility of the product in different solvents; once the solution is prepared, please store it in
separate packages to avoid product failure caused by repeated freezing and thawing.Storage method
and period of the stock solution: When stored at -80°C, please use it within 6 months; when stored
at -20°C, please use it within 1 month. To increase solubility, heat the tube to 37°C and then oscillate in an ultrasonic bath for some time. |
||
| Shipping Condition | Evaluation sample solution: shipped with blue ice. All other sizes available: with RT, or with Blue Ice upon request. | ||
| Prepare stock solution | |||
|
1 mg | 5 mg | 10 mg |
| 1 mM | 2.4601 mL | 12.3007 mL | 24.6015 mL |
| 5 mM | 492 μL | 2.4601 mL | 4.9203 mL |
| 10 mM | 246 μL | 1.2301 mL | 2.4601 mL |
Step 1: Enter information below (Recommended: An additional animal making an allowance for loss during the experiment)
Step 2: Enter the in vivo formulation (This is only the calculator, not formulation. Please contact us first if there is no in vivo formulation at the solubility Section.)
Calculation results:
Working concentration: mg/ml;
Method for preparing DMSO master liquid: mg drug pre-dissolved in μL DMSO ( Master liquid concentration mg/mL, Please contact us first if the concentration exceeds the DMSO solubility of the batch of drug. )
Method for preparing in vivo formulation: Take μL DMSO master liquid, next addμL PEG300, mix and clarify, next addμL Tween 80, mix and clarify, next add μL saline, mix and clarify.
Method for preparing in vivo formulation: Take μL DMSO master liquid, next add μL Corn oil, mix and clarify.
Note: 1. Please make sure the liquid is clear before adding the next solvent.
2. Be sure to add the solvent(s) in order. You must ensure that the solution obtained, in the previous addition, is a clear solution before proceeding to add the next solvent. Physical methods such as vortex, ultrasound or hot water bath can be used to aid dissolving.
3. All of the above co-solvents are available for purchase on the GlpBio website.
Quality Control & SDS
- View current batch:
- Purity: >99.00% Appearance: A solid
- COA (Certificate of Analysis)
- SDS (Safety Data Sheet)
- Datasheet
Average Rating: 5 (Based on Reviews and 35 reference(s) in Google Scholar.)















